Surface Heating Systems/
Surface Cooling System
mail@sl-kuehldecken.com
To save cost and to avoid Dew Point Sensor depending Systems, the alternative solution is the Cooling Tower.
The Pre-Temperature in the cooling mode can be below the Dew Point. The condensation forms on the Capillary Tubes and it can drip off into a reservoir.
That’s why this Convective Component, which does not need ventilation, and runs silently, can be used in the following applications:
In areas, where cooling ceilings cannot be used due to high Humidity.
The Cooling Tower can be combined with existing cooling ceiling.
The function of the cooling ceiling in countries with a high humidity is possible, by using the Cooling Tower to dehumidify the air.
For peak loads in conference rooms, where the out-put of the cooling ceiling is not sufficient.
In areas, where the installation of cooling ceilings is not possible.
The Cooling Tower has following advantages:
-
no noise
- simple and quiet set-up
- low maintenance, always clean – no particles adhere to the PP.
Source: Prospect Firma Clina
SL-Kuehldecken is involved world-wide in the following system applications:
Surface Heating/Cooling,
Capillary Tube Technology,
Copper Cooling Ceilings,
Pipe Systems,
Renewable Energy
